Mercathode Kit - 88334A2 Automatically protects the drive unit from galvanic corrosion. The increased output provides greater protection for underwater aluminum parts. Its reliable, efficient operation requires an insignificant amount...
Reverse Gear - 12635T This is used with 3 jaw reverse clutch. Pinion/Forward gear assembly and/or seal & bearing kit are also required. It fits Mercury 100/115/125HP 2-cycle outboards (USA...
Seal Kit - 89238A2 Due to a loss of horsepower at high altitudes, a lower gear reduction (higher numerical ratio) will enhance performance. Fits: Mercury 135/150 V6 outboards (USA 0A904646...
Primer Bulb Assembly - 8M0061876 This bulb is a 2011 EPA certified low permeation bulb, for use with our gray color, 5/16in. (8mm) ID fuel line & 3/8" ID fuel...
9 FT. Fuel Line Assembly - No Connectors - 8M0061899 There are no ends on this 9 ft. (2.74mm) fuel line assembly featuring the "EPA-MERC-PB15-2" primer bulb. Bulbs will perform...
8 FT. Fuel Line Assembly - 8M0061811 There are no ends on this 8 ft. (2.44mm) fuel line assembly featuring the "EPA-MERC-PB15" primer bulb. Bulbs will perform at -15 degrees...
Fuel Line Coupler - 8M0001721 This fuel line coupler is used to connect .375" ID fuel line to .3125" ID fuel line. Composite plastic fuel line coupler to join .375"...
On-Engine Fuel Connector - 816856Q3 Quick Disconnect fitting connector kit is for all Mercury and Mariner outboards to use the clip-on type quick disconnect fitting. The fuel line barb fitting...
Connector Kit - 804787Q This kit is for use with 5/16in. (8mm) ID fuel line. It contains both on-engine and mating fuel line connector. Connects your portable fuel tank hose...
Quick Disconnect - 13563T3 This fitting fits 40hp and larger Force outboards (1993 and newer), 9.9-25hp Force outboards (1998 models) and all Mercury and Mariner outboards using the clip-on type...
Quick Disconnect - Engine End - 14213Q This fitting fits 40hp and larger Force outboards (1993 and newer), 9.9-25hp Force outboards (1998 models) and all Mercury and Mariner outboards using...
Quick Disconnect - Tank End - 13563Q7 This fitting fits all Mercury and Mariner outboards using the clip-on type quick disconnect fitting at the fuel tank end. The fuel line...
Quick Disconnect - Tank End - 13563T7 This fitting fits all Mercury and Mariner outboards using the clip-on type quick disconnect fitting at the fuel tank end. The fuel line...
Threaded Hose Barb - 89771Q2 This fitting is for use with fuel tanks or water separating fuel filter brackets requiring a 1/4" NPT thread and hose barb for 5/16" (8mm)...
DTS Command Module Kit - Single Engine - 893377K04 SmartCraft DTS Command Module required for Gen I (2007) and newer DTS systems. Includes DTS Command Module (891661T10), panel mount harness (893377T03), key...
